KQ-455 · VORTEX/PULL
Vortex Pull
Press and hold, and the interface spirals into the pointer: a vortex that winds the page around the point, tighter the longer you hold, then unwinds on release with a little overshoot. Draws only where the pull reaches.
KQ-455 · VORTEX/PULL
Basinworks · reservoir four
Three gates, and the head is holding.
Inflow is ahead of outflow again this week, so gate two stays throttled rather than open. Press and hold anywhere on the board — the longer the grip, the harder the panel spirals toward it, and it only lets go once you do.
82% full82% full64 m³/s in64 m³/s in58 m³/s out58 m³/s out
| Gate | Head | State |
|---|---|---|
| Gate 1 | 4.2 m | open |
| Gate 2 | 3.8 m | throttled |
| Gate 3 | 0.0 m | closed |
hold, and it turns
Install
One command — the source lands in your repo. Or copy it from the Code tab.
$ pnpm dlx shadcn@latest add @kinetiq/vortex-pull
Props
| Prop | Type | Default | Description |
|---|---|---|---|
| radius / strength / windup | number | — | The vortex's reach in px, the largest twist in turns, and how fast it winds while held. |
| release | number | — | How fast it unwinds after release. |