KQ-456 · INK/PULL
Ink Pull
The interface's ink pulled toward the pointer like filings to a magnet: within reach, the dark of the page streaks toward the cursor, gathering into a bright edge at the near side and thinning on the far side, then springs back when the pointer leaves. Only the ink moves; the ground stays.
Gaugeworks · the calibration bench
Bench four is holding true.
Every needle here reads off the same manifold, checked at the top of the hour and logged before the next run starts. Nothing on the bench is loose — the ink just leans when the cursor gets close.
torque
48 N·m
range
0–600 psi
tolerance
±0.2%
drift
0.01/hr
warm-up
90 s
cycle
1.4 s
Load
412 psi412 psiSteady
98%98%the ink leans toward you
Install
One command — the source lands in your repo. Or copy it from the Code tab.
$ pnpm dlx shadcn@latest add @kinetiq/ink-pull
Props
| Prop | Type | Default | Description |
|---|---|---|---|
| radius / pull / spring | number | — | The reach in px, how far ink is pulled at the edge of reach, and how fast it returns. |
| gather | number | — | How much ink brightens where it gathers. |